Written by Tina

Electrician working on a switchboard at night (by pvproductions on Magnific)

Learning about Ohm’s Law

Electrical workshop set up at the Tools in the Trades bootcamp

Wiring a 2-gang switch, receptacle, and light fixture

Tools in the Trades electrical toolkit

Electrician starter kit

My first copper pipe cutting experience. You can see the failure at the left where I tightened the pipe cutter too tightly causing the pipe to get squished, resulting in a failed cut.

Copper:
Cutting and soldering

Galvanized pipe with a pressure gauge and a lever for turning it on and off

Working with galvanized pipe and pressurized air

The underside of a sink with faucet supply lines installed

Installing a kitchen sink drain and faucet

1 2 3 4 Next